Composite Doors
uPVC Doors
Window Frames
Internal Window Frame
Conservatories
Garage Doors
Canopies
Kitchens
uPVC Door Spraying
- Smooth finish over large surface area
- Two tone colours
- Handles removed for spraying
Key Points:
- Kolorbond paint with UV protection
- Choose any colour from all standard colour charts (RAL, BS) and most decorative colour ranges
- Matt, satin & gloss finishes available
- One-day turnaround
- 10-year guarantee
- Save up to 80%
NuColour Process
Cleaning & Degreasing
We clean the substrate using Vinylkleen and Scotchbrites which lightly abrade the surface. This stage removes all water-soluble contaminants and most oils. Next, we thoroughly clean the profile surface again using Windowprep and a clean white cloth.
Masking
This is the most time-consuming part of the job. During this stage we cover all surrounding surfaces of the profile that don't require painting to protect them from any overspray.
Spraying
Next, we use specialist materials to remove any dust or swarf remaining on the surface of the profile. We then spray the profile with a dust coat and check for any contamination before proceeding to spray a full coat.
We allow this to flash off then inspect for inclusions. If any are identified, we remove them with sand paper and apply a further coat.
Quality Check
Once spraying is complete, before we unmask the profile, an inspection across all painted surfaces is carried out to ensure we have a flawless finish.
Unmasking & Re-sealing
Finally, we unmask all surfaces and re-seal where silicone has been removed from the profile with a new, colour-coded silicone.
Small details, factory finish
Use the hotspots on the images below for a visual guide on the smaller details we pay close attention to when completing each project.
No Brush Marks
Keep The Effect
Two Tone
No Lip
Smooth Finish
Smooth & Shiny
